Omron F250-UME Software Manual page 858

Normal Serial Interface
Normal Communications
6-2-(8)
Make the settings for flow control and multi-drop connections.
1. Select Normal communications
System settings
The Communications (Normal) window will be displayed.
Communications(Normal)
2. Set the various communications parameters.
3. Select End.
The new settings will be registered and the screen in (1.) will return.
The following table shows the possible communications settings. The as-
terisk (*) indicates the default setting.
Item
Flow control None*
Xon/Xoff
Delimiter CR*
LF
CR + LF
Timeout Sets the time (in seconds) allowed before a timeout error is gen-
erated.
(1 to 120 s, default setting: 5 s)
Camera settings
Communication
Serial
Display
Normal
Operation settings
Host link
Measurement control
Parallel
Startup mode
Ethernet
Date/Time
System information
Flow control : None
Delimiter : CR
Timeout : [ 5]s
Multi-drop : OFF
Unit No. : [ 1]
End
Possible settings
Flow control is not performed.
Use this setting when saving or loading with com-
mands such as SCNLOAD and SCNSAVE.
Flow control is performed by software. Data is trans-
mitted according to the Xon/Xoff codes sent from the
external device.
Use the same setting that is being used in the per-
sonal computer.
Section 6-2