Toshiba XM-6702B User Manual page 4

Connecting Cables
IDE BUS Cable (not supplied with drive) - Your computer system should have a primary and secondary
IDE BUS, cable with your Hard Drive most likely being the Master on the primary BUS. Connect BUS cable
as follows, assuring that pin 1 of cable (side with red stripe) is connected to pin 1 of CD-ROM interface
connector:
If CD-ROM is not replacing another CD-ROM or is an addition to another
CD-ROM:
connect CD-ROM to an open connector on the secondary IDE BUS cable
(not supplied with drive).
If CD-ROM is to be slave on Primary BUS:
connect CD-ROM to open connector on the primary IDE BUS cable (not
supplied with drive).
Power Cable - Connect an internal computer power supply cable to the
power socket at the back of the CD-ROM. One side of the plug has
chamfered edges, so the power connector fits only one way. Push plug
completely into the socket making sure the plug fits correctly.
Audio Cable (optional) - If you have a sound card and speakers, and
would like to play audio CDs on your computer, you will need to get a
sound cable. Toshiba's CD-ROMs use a standard 4-pin CD-ROM audio
cable that can be purchased from most local computer suppliers. The
sound cable connects to your sound card at one end and the other end
connects to the digital audio connector at the left rear of the CD-ROM
(see CD-ROM Back Panel photo for location). Refer to the instructions
which came with your sound card for details on any sound-driver
software required.
top of page
Completing Installation
After you have connected all the necessary cables, push the CD-
ROM completely into the computer's drive slot. Mount drive per
your computer's instructions. The screw length should not
exceed 3±0.5mm (measured from outside surface of side or
bottom of CD-ROM to tip of screw). Replace computer cover and
all outer screws.
Software Driver - Toshiba's CD-ROM Drive is "plug n' play". In Windows, when you apply power to your
computer and boot-up, the system will recognize new hardware, and begin installing Window's ATAPI
driver. If you prefer using DOS, download the ATAPI driver from our web site.
Figure 3.Inserting BUS
Cable
Figure 4.Inserting Power
Cable
Figure 5.Inserting Audio
Cable
Figure 6.Mounting Illustration