Omron E5ZN-DRT Datasheet page 6

Notice
Observe the following points to ensure safe operation.
• Set the communications distance to within the range specified in
the E5ZN-DRT User's Manual (Cat. No. H119).
• Do not place communications cables close to or parallel to high-
voltage lines or power lines.
• Use the communications cables specified in the E5ZN-DRT User's
Manual (Cat. No. H119).
• Do not attempt to disassemble, repair, or modify the product.
• Do not drop the product or expose it to excessive shocks or vibra-
tions. Doing so may result in malfunctions.
• Always use the power supply voltage within the specified range.
• Do not pull on the cables or bend the cables beyond their natural
limit.
• Confirm that the power is OFF before wiring.
• Be sure to perform wiring for communications lines and power sup-
plies correctly. Be sure to wire to terminals with the correct polarity.
Incorrect wiring may result in malfunctions.
• Confirm that the power is OFF before mounting or removing con-
nectors. Mounting or removing connectors with the power ON may
result in malfunctions.
• Double-check all wiring and switch settings before turning ON the
power supply.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. H120-E1-01
I-150
DeviceNet Communications Unit
In the interest of product improvement, specifications are subject to change without notice.
E5ZN-DRT
Notice
• Do not use the product in the following locations
Locations exposed to direct sunlight
Locations subject to intense temperature changes
Locations subject to freezing or condensation
Locations subject to dust or corrosive gases (in particular, sulfide
gas and ammonia gas)
Locations subject to exposure to water or oil
Locations subject to vibrations or shocks
• Take appropriate and sufficient countermeasures when installing
systems in the following locations:
Locations subject to static electricity or other forms of noise.
Locations subject to strong electromagnetic fields.
Locations subject to possible exposure to radioactivity.
Locations close to power lines with high voltage or large current.
• Use the product within the specified temperature and humidity
ranges.
• Take appropriate measures to ensure that the specified power with
the rated voltage and frequency is supplied in places where the
power supply is unstable.
• Do not use solvents to clean the product.
• Confirm that the power is OFF before replacing the product.