Download Print this page
Omron D5F Datasheet
Omron D5F Datasheet

Omron D5F Datasheet

High-precision optical switch

Advertisement

Quick Links

High-precision Optical Switch
Optical System Achieves 1-mm
Operating Position Repeatability in this
4-way Switch
I
A knife-edge mechanism in the optical system
provides greater precision for a more stable out-
put without faulty contact operation.
I
Reduced size and weight (34 mm at operating
section and 60 g total).
I
Wear-resistive ceramic parts used in the mea-
surement section.
I
Two different output types available.

Ordering Information

List of Models
I
Output configuration
PNP open collector
SPST-NC
(+ common)
NPN open collector
SPST-NO
(– common)

Specifications

Ratings
I
Power supply voltage
Output current
Power consumption
Leakage current
Residual voltage
Characteristics
I
Degree of protection
Life expectancy (see note 2)
Operating speed
Max. operating frequency
Insulation resistance
Dielectric strength
Vibration resistance
Shock resistance
Repeat accuracy
Ambient temperature (see note 4)
Ambient humidity
Weight
Note:
1. The above figures are initial values.
2. Life expectancy values are calculated at an operating temperature of 5
Contact your OMRON sales representative for more detailed information on other operating environments.
3. Measurements were conducted repeatedly at the same point. The value is 1
tions in detail, contact your OMRON sales representative.
4. The ambient operating temperature varies depending on the current. Refer to the following Engineering Data.
280
Contact form
Operation indicator
ON when not operated
ON when operated
12/24 VDC
10%, ripple (p–p): 10% max.
100 mA max.
30 mA max.
0.15 mA max.
2 V max.
IP67
Mechanical: 5,000,000 operations min.
Electrical:
5,000,000 operations min.
m
1
m/s to 50 cm/s
60 operations/minute max.
W
100 M
min. (at 500 VDC) between each terminal and ground
1,100 VAC between each terminal and ground
Malfunction: 10 to 500 Hz, 1.3-mm double amplitude
Malfunction: 300 m/s
m
1
m max. (see note 3)
Operating: –10
C to 60
Operating: 30% to 95%
Switch body: approx. 50 g; Cord: 23 g/m
Cable length
1 m
3 m
1 m
3 m
2
min.
C (with no icing)
C to 35
C, and an operating humidity of 40% to 70%.
m max. for 200 measurements. For other condi-
m
D5F
Model
D5F-2B10
D5F-2B30
D5F-3C10
D5F-3C30

Advertisement

loading

Summary of Contents for Omron D5F

  • Page 1: Ordering Information

    3. Measurements were conducted repeatedly at the same point. The value is 1 m max. for 200 measurements. For other condi- tions in detail, contact your OMRON sales representative. 4. The ambient operating temperature varies depending on the current. Refer to the following Engineering Data.
  • Page 2 1,000,000 operations Temperature coefficient –6 50 x 10 C max. – • Note: :Operating position fluctuation rate for a change of 1 C in the ambient temperature. • Operating Characteristics OF max. 2.45 N RF min. 0.98 N PT max.
  • Page 3 Repeat Accuracy (Reference Data) D5F-2B10 No. 1 ON No. 2 ON No. 1 OFF No. 2 OFF No. 3 ON No. 4 ON No. 3 OFF No. 4 OFF...
  • Page 4 Nomenclature LED indicator O ring (NBR) Photodiode (for signal) Seal cap (NBR) Ceramic chip Ball lens Photodiode (for monitoring) Half mirror O ring (NBR) LED light source Seal rubber (NBR)
  • Page 5: Output Circuit

    16 dia. 24 dia. 18 dia. Replace @ in the model number with the code for the Switch you require (i.e. 1 for Switches with a 1,000-mm cable and 3 for Switches with a 3,000-mm cable). Note: The degree of parallelism and squareness of the ceramic chip are ±5 µm/5 mm against the reference plane.
  • Page 6: Operation

    The chips can withstand certain cutting oils or ace- mum. tone. Check the operating environment before using the D5F. ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. Cat. No. C117-E1-1...

This manual is also suitable for:

D5f-2b10D5f-2b30D5f-3c10D5f-3c30