Flat Cable Ii - Omron CRT1 - 10-2008 Operation Manual

Preparing Flat Connectors
Note
3-3-3

Flat Cable II

Preparing DCN5-TR4 Flat Connector Sockets
Component Names
Pliers
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
(1) Do not pressure-weld the connector cover at the edges.
(2) Do not pressure-weld the connector cover at the back of the pressure-
welding block.
(3) Set the connector in the correct orientation.
OK
NG
3. After attaching the cable, confirm that it is properly pressure-welded as
shown below.
Be sure there are no gaps here.
■ Cutting the Cable
Cut the cable perpendicular to the length.
Connector cover
NG
NG
Cover
Section 3-3
59