Preparing Flat Connectors
3-3-1
Round Cable II
Preparing DCN4-TR4 Flat Connector Sockets
Component Names
This procedure is only required to connect a Terminating Resistor.
Cover
Cable labels
(Black, blue/green, white, and red)
Cable confirmation slot
■ Preparing the Cable
Cut the cable perpendicular to the length, and strip the sheath as shown in the
following diagram.
■ Setting the Cable Stopper
Set the Cable Stopper.
Close the cover, secure the hooks, and then press down on the cable stopper
until it clicks into place.
Housing
Black
Green or blue
Cable stopper
Section 3-3
Red
White
Black
53