Maintenance And Care; Disposal - Parkside KH 3001 SOLDERING PENCIL Introduction Manual


The nominal soldering tip temperature is about
320° C. For best results use electronics solder
1.0 (10 g included with the soldering pencil) or
1.5 mm dia. 60 % Sn. We recommend solder-
ing paste (not soldering grease or soldering
fluid) as a flux.

The design of the soldering pencil makes it
especially suitable for use where access is
difficult or for fine soldering work. The inter-
changeable tips increase the versatility of the
soldering pencil.

Maintenance and care


 Attention: Always make sure that the mains
plug is out of the socket before doing any work
on the random orbital sander.
Operation/Maintenance and care/Disposal
1) Clean the sander frequently; for best results,
do this immediately after you have finished
using it.
2) Do not use sharp objects for cleaning the
random orbital sander. Do not allow any liquids
to enter the random orbital sander. Use a soft
cloth to clean the housing – under no circum-
stances use petrol, solvents or cleaning agents
that attack plastic.

Disposal


The packaging is wholly composed of environmen-
tally-friendly materials that can be disposed of at
a local recycling centre. Please contact your local
council office to find out about disposal facilities for
your worn-out electrical tools.
GB 11