Operation - Parkside KH 3001 SOLDERING PENCIL Introduction Manual

Safety/Operation
screw must be fully tightened.
· When removing the soldering tip make sure
that the soldering pencil is switched off and do
not use too much force. Slide a new soldering
tip fully in so that it hits the stop.
· Do not heat up the soldering pencil without a
tip in place.
· After use let the soldering pencil cool down in
air only. Under no circumstances quench the
tip in water!
· Place the soldering pencil in the stand during
any pauses in your work.
Danger of fire! Place the soldering pencil
·
down only in the special stand or on a fire-
resistant support pad.
· If danger arises, pull the mains plug immedi-
ately out of the mains socket.
· Never use the device for a purpose for which it
was not intended.
10 GB
· Handle the device carefully and treat it with
respect. Always keep the device clean, dry and
free of oil or grease.
· Remain alert at all times! Watch what you are
doing and always proceed with caution. Do not
use the device if you cannot concentrate or
you are feeling unwell.

Operation


Note the mains voltage. The mains voltage must
correspond with that shown on the sander rating
plate. Equipment labelled as 230 V may also be
used with 220 V.

The soldering pencil PFLK 30, with its nominal
30 watt power rating, is ideal for soldering
electronic components and circuit boards.