HP StorageWorks DAT Series Troubleshooting Manual page 2

12. Decode driver errors.
13. Check application event
14. Check if you have a Netware operating system
15. Check if you have a Tapeware software
16. Check if you have a Colorado Backup
17. Check if you have an Arcserve
18. HP Support contact details.
Software/application troubleshooting details
Run Device Analysis test in Library and Tape Tools
Action recommended
Run the Device Analysis Test in HP Library and Tape Tools
(L&TT). Follow any troubleshooting given with the test
results.
NOTE:
Due to issues in development Library and Tape
Tools cannot be reliably used to diagnose potential
issues with the DAT 40 Hotplug drive (Q1546A
only). This problem is currently being investigated
and will be corrected in the next revision of Library
and Tape tools. This note will be updated once the
problem has been corrected but until then do not
use Library and Tape Tools to diagnose issues with
this product.
This problem only relates to the Q1546A product, no other
DAT 40 variants are affected.
Back to Start of Section
Back to Top
Check driver is correct and installed
Action recommended
Check driver is correct and
installed.
Back to Start of Section
Back to Top
If NT4 - check driver location in the operating system
Action recommended
Check operating system drivers in the
winnt/system32/drivers directory.
logs.
issue.
issue.
issue.
issue.
Additional information
Click here for information on drivers and
operating systems.
Click here for information on tape
drive detection and other
Additional
information
Click here for
information on HP
Library and Tape
Tools.
Additional information