Configuring The Menu Language Of The Software; Configuring The Pc In A Network - Sennheiser SDC 8200 SYS Software Manual

Configuring the conference system
44
This setting is recommended for conference systems with an
unchanging configuration.

Configuring the menu language of the software

To display the menus and buttons of the software in a different language
immediately after program startup:
In the "Language" box on the "Confsys" tab, click the desired option
button.
Note:
You can change the menu language at any time (see "Changing the
menu language of the "Confsys" program" on page 21).

Configuring the PC in a network

If you have installed the software in parallel on several PCs, it is necessary
to specify the tasks of the PCs in the network:
Master:
Control of the conference system and/or control of the interpretation
system, access control (dongle)
Slave:
Control of the conference system and/or control of the interpretation
system
Video:
Display of the synoptic view of the conference room, the delegate names
and the voting results (e.g. via a projector)
Note:
Your network administrator will give you the required TCP/IP addresses
of your PCs.
If the PC is to be configured as the master PC:
In the "Program" box on the "Confsys" tab, click the "Master" option
button.
Enter the TCP/IP addresses of the corresponding PCs in the "Master",
"Slave1" and "Video" boxes of the "TCP/IP address" box.
This PC is now configured as the master PC.