Monitoring The Audio Signal Via Headphones - Sennheiser EM 500 G3 - 02-09 Manual

To completely switch the receiver off:
Disconnect the receiver from the mains by unplugging the mains unit
from the wall socket.
The backlighting of the

Monitoring the audio signal via headphones

CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent
hearing defects.
Set the headphone volume control
putting the headphones on.
Set the headphone volume control
Connect headphones with a ¼" (6.3 mm) stereo jack plug to the head-
phone output
Gradually increase the volume and monitor the audio signal with the
lowest possible volume.
Keep the STANDBY
the display panel.
The receiver switches to standby mode.
When in the operating menu, pressing the
cancel your entry (ESC function) and return you to the current
standard display.
The STANDBY button
in standby mode.
STANDBY
.
button pressed until "OFF" appears on
STANDBY
is backlit in red both during operation and
button goes off.
to the minimum position before
PEAK B.Ch: 20.30
ew500 G3
40 0
-10 542.625 MHz
30
-20
20
-30 SKM500
EQ
10
-40
P P + 12dB
RF AF
to the minimum position.
Using the receiver
button will
21