Using The Receiver; Switching The Receiver On/Off; Monitoring The Audio Signal Via Headphones - Sennheiser EM 2000 - 01-09 Instruction Manual

Using the receiver

**2000**
.200 MHz
SKM2000
UTE
CAUTION!
B.Ch:
PEAK
True Diversity Receiver EM 2000
40 0
-10
30
-20
20
-30
EQ:
10
-40
P + 1
RF AF
14
Using the receiver
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see next section).
2. Switch the transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the display backlighting of the receiver changes
from red to orange.
It is vital to observe the notes on frequency selection on page 31.
If you cannot establish a transmission link between transmitter and receiver, read the
chapter "Synchronizing transmitters with receivers" on page 31.

Switching the receiver on/off

To switch the receiver on:
Briefly press the
The receiver switches on and the
appears.
To switch the receiver to standby
Keep the STANDBY
The receiver switches to standby mode. The integrated antenna splitter and the
booster supply voltage remain active so that the antenna signals are still looped
through to daisy-chained receivers.
• When in the operating menu, pressing the
entry (ESC function) and return you to the current standard display.
• The STANDBY button
mode.
To completely switch the receiver off:
If necessary, deactivate the lock mode (see page 15).
Disconnect the receiver from the mains by unplugging the mains cable plug from the wall
socket.
The backlighting of the

Monitoring the audio signal via headphones

Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
Set the headphone volume control
phones on.
Set the headphone volume control
Connect headphones with a ¼" (6.3 mm) stereo jack plug to the headphone output
Gradually increase the volume and monitor the audio signal with the lowest possible
volume.
STANDBY button .
"Receiver
mode:
button pressed until "OFF" appears on the display panel.
is backlit in red both during operation and in standby
STANDBY button goes off.
to the minimum position before putting the head-
to the minimum position.
Parameters" standard display
STANDBY button will cancel your
.