Using The Receiver; Switching The Receiver On/Off; Monitoring The Audio Signal Via Headphones - Sennheiser EM 2000 Instruction Manual

**2000**
.200 MHz
SKM2000
UTE
CAUTION!

Using the receiver

To establish a transmission link, proceed as follows:
1. Switch the receiver on (see below).
2. Switch the transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the display backlighting of the receiver changes
from red to orange.
It is vital to observe the notes on frequency selection on page 29.
If you cannot establish a transmission link between transmitter and receiver:
Make sure that transmitter and receiver are set to the same frequency.
If necessary, read the chapter "If a problem occurs ..." on page 31.

Switching the receiver on/off

To switch the receiver on:
Briefly press the
The receiver switches on and the
appears.
To switch the receiver to standby
If necessary, deactivate the lock mode (see page 14).
Keep the STANDBY
The integrated antenna splitter and the booster supply voltage remain active so
that the antenna signals are still looped through to daisy-chained receivers.
• When in the operating menu, pressing the
entry (ESC function) and return you to the current standard display.
• The STANDBY button
mode.
To completely switch the receiver off:
Disconnect the receiver from the mains by unplugging the mains cable plug from the wall
socket.
The backlighting of the

Monitoring the audio signal via headphones

You can monitor the audio signal via the headphone output.
Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
Set the headphone volume control
phones on.
.
STANDBY button
"Receiver
mode:
button pressed until "OFF" appears on the display panel.
is backlit in red both during operation and in standby
STANDBY button goes off.
to the minimum position before putting the head-
Using the receiver
Parameters" standard display
STANDBY button will cancel your
13