Using The Devices - Sennheiser 100-P G3 Instruction Manual

Using the devices

16
Plugging the plug-on transmitter onto a microphone
Plug the microphone's XLR-3M socket onto the transmitter's XLR-3F socket
Tighten the locking ring
The transmitter uses the microphone body as an antenna – therefore microphones
with a metal casing should be used for best signal transmission.
Using the devices
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on.
2. Switch a transmitter on.
The transmission link is established and the diversity receiver's RF level display "RF"
reacts.
If you cannot establish a transmission link between transmitter and diversity receiver:
Make sure that transmitter and diversity receiver are set to the same frequency bank and
to the same channel.
If necessary, read the chapter "If a problem occurs ..." on page 29.
It is vital to observe the following notes:
Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
in the direction of the arrow.
.