Skm 100 G3 Radio Microphone - Sennheiser 100-P G3 Instruction Manual

Attaching the bodypack transmitter to clothing
You can use the belt clip
band).
The belt clip is detachable so that you can also attach the transmitter with the antenna
pointing downwards. To do so, withdraw the belt clip
the other way round. The belt clip
accidentally.
To detach the belt clip:
Lift one side of the belt clip as shown in the diagram on the right-hand side.
Press down the belt clip at one fixing point and pull it out of the transmitter housing.
Repeat for the other side.

SKM 100 G3 radio microphone

Only hold the radio microphone by its body.
If you touch the antenna of the radio microphone during operation, the trans-
mitter's range will be considerably reduced!
Inserting the batteries/accupack
For powering the radio microphone, you can either use two 1.5 V AA size batteries or the
rechargeable Sennheiser BA 2015 accupack.
Unscrew the lower part of the radio microphone from the radio microphone's body
turning it counterclockwise.
When unscrewing the radio microphone during operation, the muting function is
automatically activated. "MUTE" appears on the display panel.
When screwing the lower part of the radio microphone back to the radio micro-
phone's body, the muting is canceled.
Slide back the lower part of the radio microphone as far as it will go.
Open the battery compartment cover
Insert the batteries or the BA 2015 accupack as shown on the battery compartment
cover. Observe correct polarity when inserting the batteries/accupack (see page 14).
to attach the bodypack transmitter to clothing (e.g. belt, waist-
is secured so that it cannot slide out of its fixing points
(see page 14).
Putting the devices into operation
from its fixing points and attach it
by
13