Basic Recording For Video - THOMSON VMD10 User Manual

16
EN
Shooting Mode Dial
min 90 min
(Now calculating)
0 min
(Blinking)
Tally lamp
(lights while recording
is in progress)
+
BR I GHT –
180 90
PUSH-OPEN Button
Power Switch
Power lamp
Lock Button
Recording
Start/Stop Button
Display
2 5
Tape remaining
time indicator
(Approximate)
89 min 3 min
1 min 2 min
(Blinking) (Blinking)
MENU/
BRIGHT Wheel
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
Power ( pg. 6)
Grip Adjustment (
Viewfinder Adjustment (
Load A Cassette (
Recording Mode Setting (
1
Set the Shooting Mode Dial to "VIDEO", then set the
Power Switch to "
the Lock Button located on the switch.
Shooting while using the viewfinder: Make sure the
LCD monitor is closed and locked. Pull out the
viewfinder fully.
•Be sure to pull out the viewfinder until you hear a
click, otherwise it may be pushed back in during
use.
Shooting while using the LCD monitor: Make sure
the viewfinder is pushed back in. Press PUSH-OPEN
and open the LCD monitor fully. Tilt it upward/
downward for best viewability.
•The power lamp lights and the camcorder enters the
Record-Standby mode. "PAUSE" is displayed.
2
Press the Recording Start/Stop Button. "
while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
To Adjust The Brightness Of The Display
.... rotate MENU/BRIGHT until the bright level indicator
on the display moves and the appropriate brightness is
reached.
•It is also possible to adjust the brightness of the view-
finder.

Basic Recording For Video

pg. 8)
pg. 8)
pg. 10)
pg. 11)
" or " " while pressing down
" appears