Using The Battery Pack; Using Ac Power - THOMSON VMD10 User Manual

1
3
ATTENTION:
Before detaching the power source,
make sure that the camcorder's power
is turned off. Failure to do so can result
in a camcorder malfunction.

USING AC POWER

Use the AC Power Adapter/Charger (connect as shown in the illustration).
NOTES:
The provided AC Power Adapter/Charger features automatic voltage selection in the AC range from 110 V to
240 V.
For other notes, pg. 6.
BATT. RELEASE
Button
2
To battery
pack mount

USING THE BATTERY PACK

1
Tilt the viewfinder upward
2
With the arrow on the battery pack pointing
downward, push the battery pack slightly against the
battery pack mount
3
pack to attach it
•If the battery pack is attached with its
in the wrong direction, a malfunction may occur.
To Detach The Battery Pack. . .
.... tilt the viewfinder upward
pack up slightly while pressing BATT. RELEASE to
detach it.
Approximate recording time
Battery pack LCD monitor on/
Viewfinder off
BAT2000 1hr. 5 min.
NOTES:
Recording time is reduced significantly under the
following conditions:
• Zoom or Record-Standby mode is engaged repeatedly.
• The LCD monitor is used repeatedly.
Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
Power cord
AC Power
Adapter/Charger
AC2000
DC cord
1
.
2 , then slide down the battery
.
1
and slide the battery
LCD monitor off/
Viewfinder on
1 hr. 20 min.
To AC outlet
To DC OUT
connector
7
EN
mark set