Video Processor 1 Board - THOMSON STUDIO CAMERA LDK 20(S) Technical Manual

Video Processor 1 Board

Setting-up the Camera
Note:
Video Processor 1 must be adjusted in combination with the Sync./Shading board.
1. For local powering of the camera in the stand-alone mode (see User Guide, Section 4).
2. Recall Factory Standard File on MCP or OCP.
On MCP set:
OPERATE MENU
Knee
Contour
Gamma
Blk. Str.
Auto Iris
SETUP 1 MENU
Studio mode:
Flare
White clip
SETUP 2 MENU
Soft cont.
SETUP 3 MENU
Skin cont.
SETUP 4 MENU
Notch
Chroma
Asp. Ratio
SETUP 5 MENU
Matrix sel. :
MAINT. 1 MENU
Wh. shading :
Oscilloscope: 10mV/div. probe 10:1
3. Put Video Processor 1 on a service extender.
4. Remove jumpers 7, 9, 11, 13, 17 and 19 from connector B of the service extender to interrupt the input from
the front and jumpers 6, 12 and 15 to interrupt the black shading correction.
5. Short circuit the input to video processor 1 by connecting the following jumpers on connector B of the service
extender:
B7 to B9
B11 to B13
B17 to B19
Adjustments
: Off
: Off
: Lin.
: Off
: Off
Off
: Off
: Off
: Off
: Off
: Off
: Off
: 4:3
1:1
Off
Technical Manual LDK 20(S) - Studio Camera 4-5