Road Armor 60802B Install Instructions

2008-2010
Ford SuperDuty
Front Bumper
INSTALL
INSTRUCTIONS
Read the instructions completely before beginning the installation. Before tightening bolts, drilling or
cutting where required, check to make sure that there are no obstructions such as brake, fuel or electri-
cal lines that may be damaged. Also keep in mind this is an aftermarket product and MAY require some
minor shimming and or trimming, reaming etc. to fit properly.
IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED.
BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE SURFACE PREPARATION BEFORE
HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.
ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS WITH FIT OR FINISH ARE NOT
NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.
PIAA 510 - www.piaa.com - Part Numbers (5161, 5164, 5192, 5190, 5196).
Warn 350F - www.warn.com Part Number (82410).
-Yourself and a strong friend / bumper jack.
- Socket set, Ratchet & Wrenches (metric & standard)
( ... more than likely metric for your rig, cause everything's imported these days,
- Common Sense a Tape Measure and a bit of Patience
Warning!
IMPORTANT NOTICE
THANK YOU
SUGGESTED LIGHTS THAT FIT THIS UNIT:
TOOLS NEEDED
( Don't worry, we're not calling you or your friend a "tool" )
and standard for your new bad ass Made in USA bumper.
Road Armor thanks you for supporting the American Economy! )
- Cut off wheel, Sawzall, ect.
( And also a cold drink to celebrate afterwards )