THOMSON REMOTE COMMUNICATION - V3.0 User Manual page 77

SECTION 3
byte4,
byte5
byte6,
byte7
PM055 Rev 2 00/08/31
59 = Src1 ready, Src2 auto
60 = Src1 ready, Src2 failed
61 = Src1 ready, Src2 normal
62 = Src1 ready, Src2 offload test
63 = Src1 ready, Src2 onload test
64 = Src1 ready, Src2 ready
65 = Src1 ready, Src2 running
66 = Src1 ready, Src2 starting
67 = Src1 ready, Src2 switch off
68 = Src1 running, Src2 auto
69 = Src1 running, Src2 failed
70 = Src1 running, Src2 normal
71 = Src1 running, Src2 offload test
72 = Src1 running, Src2 onload test
73 = Src1 running, Src2 ready
74 = Src1 running, Src2 running
75 = Src1 running, Src2 starting
76 = Src1 running, Src2 switch off
77 = Src1 starting, Src2 auto
78 = Src1 starting, Src2 failed
79 = Src1 starting, Src2 normal
80 = Src1 starting, Src2 offload test
81 = Src1 starting, Src2 onload test
82 = Src1 starting, Src2 ready
83 = Src1 starting, Src2 running
84 = Src1 starting, Src2 starting
85 = Src1 starting, Src2 switch off
86 = Src1 switch off, Src2 auto
87 = Src1 switch off, Src2 failed
88 = Src1 switch off, Src2 normal
89 = Src1 switch off, Src2 offload test
90 = Src1 switch off, Src2 onload test
91 = Src1 switch off, Src2 ready
92 = Src1 switch off, Src2 running
93 = Src1 switch off, Src2 starting
94 = Src1 switch off, Src2 switch off
95-255 = Unused
This field contains the system status timer value (in seconds).
This field contains the fault state bitmap. Each bit contains TRUE
if the associated fault is active. The bits are defined as follows:
Bits 15-8 are unused.
Bit 7 is Src2 over frequency.
Bit 6 is Src2 under frequency.
Bit 5 is Src2 over voltage.
Bit 4 is Src2 under voltage.
Bit 3 is Src1 over frequency.
Bit 2 is Src1 under frequency.
Bit 1 is Src1 over voltage.
71
CIM PROTOCOL
Thomson Technology