THOMSON REMOTE COMMUNICATION - V3.0 User Manual page 71

SECTION 3
byte2, byte3
byte4, byte5
byte6, byte7,
byte8, byte9
byte10, byte11
byte12, byte13 This field contains the oil pressure (in KPA or PSI).
Analog Group 1 Registers are described in more detail below:
Analog Group 1
Data
byte0, byte1
byte2, byte3
byte4, byte5
byte6, byte7
byte8, byte9
byte10, byte11
byte12, byte13
byte14, byte15
PM055 Rev 2 00/08/31
is in degrees Fahrenheit.
Bit 14 contains TRUE if the oil pressure is in KPA, and
FALSE if the oil pressure is in PSI.
Bit 13 contains TRUE if 3 phase mode, and FALSE if 1
phase mode.
Bits 12-0 are unused.
This field contains the battery voltage (in tenths of volts).
This field contains the engine RPM (in revolutions per
minute).
This field contains the run hours (in hours).
This field contains the engine temperature (in degrees
Celsius or degrees Fahrenheit).
Description
3 phase mode: This field contains the phase AB voltage
(in volts).
1 Phase mode: This field contains the phase AB voltage
(in volts).
3 phase mode: This field contains the phase BC voltage
(in volts).
1 Phase mode: This field contains the phase AN voltage
(in volts).
3 phase mode: This field contains the phase CA voltage
(in volts).
1 Phase mode: This field contains the phase BN voltage
(in volts).
3 phase mode: This field contains the average of the
phase AB, BC, and CA voltages (in volts).
1 Phase mode: This field contains the phase AB voltage
(in volts).
3 phase mode: This field contains the phase A current
(in amps).
1 Phase mode: This field is unused.
3 phase mode: This field contains the phase B current
(in amps).
1 Phase mode: This field contains the phase A current
(in amps).
3 phase mode: This field contains the phase C current
(in amps).
1 Phase mode: This field contains the phase B current
(in amps).
3 phase mode: This field contains the average of the
phase A, B, and C currents (in amps).
65
CIM PROTOCOL
Thomson Technology