THOMSON REMOTE COMMUNICATION - V3.0 User Manual page 43

SECTION 2
After the desired controller is selected and the OK button clicked one of two
dialog boxes is presented: one for the MEC 20 and one for the TSC 800. The
MEC 20 properties dialog box is shown in the following figure. From this window,
the description can be modified and other properties, such as the controller
address and the fault-labels, can be viewed.
The TSC 800 properties dialog box is shown in the next diagram. From here, the
controller description can be modified. Additional properties, such as the
controller address, can be viewed.
PM055 Rev 2 00/08/31
THS 2000 SOFTWARE PROGRAM
37
Thomson Technology