HOMCOM 820-048 Assembly & Instruction Manual page 3

● CAUTION: Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
● WARNING: This heater is not equipped with a device to control the room temperature. Do
not use this heater in small rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is provided.
● Regarding the instructions for replacing bulb, thanks to refer to the below paragraph of
the manual.
● TO RESET TERMPERATURING LIMITING CONTROL DISCONNECT POWER USING
PLUG CAP OR MAIN SWITCH FOR 5 MIN.
● Hyperthermia can result in death. Symptoms of hyperthermia include high body
temperature, headache, nausea, vomiting, tiredness, dizziness, fainting, and rapid pulse.
If you begin to experience symptoms related to hyperthermia, turn off the heater and
seek medical attention.
● To avoid excessive room temperatures which can cause hyperthermia: DO NOT leave
product running unattended in a confined space around infants, or individuals with
reduced physical, sensory, or mental capabilities.
Getting Started
● Remove the appliance from the box.
● Remove any packaging from the product.
● Place the packaging inside the box and either store or dispose of safely.
Contents of Carton
● Heater.
● 1 instruction Manual.
Operation Instructions
● Caution: This heater should free from noticeable vibration when it is operating, this could cause
the bulb break down. Please turn the heater off firstly before movement, maintenance or clearing.
● The heater controls are located on the back side of the heater. Three rocker switches provide a
choice of heat settings.
● Switch 1 (l) Switchs on/off electricity supply to the heater and flame effect.
Note: This switch must be in the ON (l) position for heater to operate with or without heat.
● Switch 2 (l) Switchs on/off 500W heat output.
● Switch 3 (ll ) Switchs on/off 1000W output with switch 2.
Note: The flame effect can be operated with or without heat.
To adjust the permanent temperature:
1) Turn the thermostat clockwise to the biggest point.
2) When the room temperature goes up to be comfortable then turn the switch in an anticlockwise to
break point and keep the button position.
3) The function can keep necessary room temperature and also save energy.
SAVE THESE INSTRUCTIONS.
3