Handling And Storage; Handling To Avoid Damage; Handling To Avoid Accidental Tamper - Magtek iDynamo 5 Gen III Installation And Operation Manual

3 - Handling and Storage

3 Handling and Storage
Proper handling of the device throughout delivery, assembly, shipping, installation, usage,
and maintenance is very important. Not following the guidelines in this document could
damage the device, render it inoperable, and/or violate the conditions of the warranty.
3.1

Handling to Avoid Damage

Upon receiving the device, inspect it to make sure it originated from an authentic source and has not been
tampered with. For details, see D998200620 iDynamo 5 Gen III SRED, Device Inspection Manual,
available from MagTek.
From device delivery through assembly, shipping, installation, usage, and maintenance, the device must
not be exposed to conditions outside the ratings in Appendix A Technical Specifications.
If the device is exposed to cold temperatures, adjust it to warmer temperatures gradually to avoid
condensation, which can interfere with the operation of the device or cause permanent damage.
Do not drop or shake the device.
For information about ongoing maintenance of the device, such as cleaning, see section 7 Maintenance.
3.2

Handling to Avoid Accidental Tamper

iDynamo 5 products that are PCI certified implement an active tamper detection, which uses a small
amount of electricity even when the device is completely powered off. To avoid accidental tamper events
follow these precautions:
•
Store the device at the lowest reasonable temperatures within its specified storage temperature
range (see Appendix A Technical Specifications). Storing at temperatures between -4°F to 113°F
(-20°C to 45°C).
•
Do not drop or shake the device.
•
Do not attempt to disassemble the device.
iDynamo 5 Gen III| Secure Card Reader | Installation and Operation Manual
Page 11 of 31 (D998200614-100)