Warranty Coverage; Maintenance Table; Troubleshooting - Stiga BL 500e Kit Operator's Manual

• It is advisable to send your machine
once a year to an Authorised Service
Centre for servicing, assistance
and safety device inspection.

11. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover damage caused by:
• failure to become familiar with the
documentation accompanying the machine;

12. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check the battery charge status
Recharge the battery
Cleaning the machine and the engine
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
* Refer to the battery/battery charger manual.

13. TROUBLESHOOTING

PROBLEM
1. The machine does not
start when the throttle
control is activated
2. The motor shuts
down whilst working
3. The rotor rotates, but
the air does not come
out from the blower tube
4. Excessive noise and/or
vibration is experienced
whilst working
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Faulty throttle control or
damaged blower
Battery is not inserted correctly
Low battery
Blocked or clogged blower tube
Loose or damaged parts
• carelessness;
• incorrect or forbidden use or assembly;
• use of non-genuine spare parts;
• use of attachments not supplied or
not approved by the manufacturer.
The warranty does not cover:
• normal wear and tear of
consumable materials;
• normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
Frequency
Before each use
Before each use
Before each use
After each use
After each use
After each use
Make sure that the battery is
inserted correctly (para. 7.2.3)
Check the battery status and recharge
if necessary (para. 7.2.2)
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Make sure that the battery is
inserted correctly (para. 7.2.3)
Check the battery status and recharge
if necessary (para. 7.2.2)
Stop the machine,
and remove any obstructions.
Turn off the machine
–
inspect for damage;
–
check for and tighten any loose parts;
–
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
EN - 14
Notes
para. 7.4
para. 6.2
*
para. 7.2.2
*
para. 7.3
-
SOLUTION
remove the battery
remove the battery
remove the battery and: