Rear Panel - BRUEL & KJAER 2313 Instruction Manual

Set-Up:
Exec./Ent:
Active LED:
Talk LED:
Listen LED:
Control LED:
Entering LED:
2.2. REAR PANEL
Address Switch:
Voltage Selector
and Fuse
On-Off key, selecting the Set-Up mode ready for entry of the date
and time of day with the built-in clock of the Recorder (see section
3.5). The built-in LED of the key plus the Entering LED light when the
Set-Up mode is active.
Executes a command or terminates entry of data via the front panel
pushkeys. The built-in LED of key lights when Exec./Ent. is activated
and command execution is in progress.
Lights when the Recorder is used as a system controller (e.g. Ad-
dress Switch set for "System Controller Active"), and data is not
being entered. Indicates that the Recorder is ready to accept a func-
tion via the front panel pushkeys of the instrument.
Lights when the Recorder is sending data over the IEC Interface.
Lights when the Recorder is receiving data over the IEC Interface.
Lights when the Recorder is sending IEC control commands over the
IEC Interface.
Lights when the Recorder is ready to accept numerical data entered
via the front panel pushkeys of the instrument or sent over the IEC
Interface.
Device Address
switches
'{·---
........
}
1
!=~---
1::
=. .
~
,
...
,,...
Interface Bus
Serial Interface
Fig. 2.4. Rear panel of the Graphics Recorder Type 2313
A set of eight miniature two-position rocker switches for manual se-
lection of the device address number for the digital interface bus of
the 2313, plus selection of "System Controller Active/Not Active" and
"Metric/English" page length. On delivery the Address Switch num-
bers AS to A 1 are set to 00001 (ie., device address number 1 ). See
section 4.3.1.
7