Paper Loading And Cleaning Of The Print Head - BRUEL & KJAER 2313 Instruction Manual

....
-·-
,
••
,,,.,:~
·-
•••••• ==
iii
iii
--, - i
f \
Fig. 3.3. Installation of Application Package
3.3. PAPER LOADING AND CLEANING OF THE PRINT HEAD
Drive Spindle
To load the 2313 with a fresh roll of Paper QP 4690, proceed as follows:
1. Press down the Release Catch on the front panel and pull forward the paper drive
frame as shown in Fig. 3.4.
Paper Spindle
Take-Up Slot
Release Arm
Fig. 3.4. The Paper Drive Frame of the 2313
2. Lower the Release Arm on the left of the drive frame and lift out the paper spindle
together with the remainder of the old paper roll if one is fitted.
3. Wipe a soft lint-free cloth along the rear of the print head to remove traces of
print dust which may have accummulated during previous use. See Fig. 3.5.
4. Slide a fresh roll of Paper QP 4690 onto the paper spindle and position it so that
its adhesive label is on top of the roll with arrow pointing towards the front panel.
See Fig. 3.4.
13