Related Manuals for YOKOGAWA 701913
Summary of Contents for YOKOGAWA 701913
- Page 1 User’s Model 701913 Manual PBA2500 Active Probe IM 701913-01E 2nd Edition Yokogawa Electric Corporation...
-
Page 2: Foreword
Foreword Thank you for purchasing the PBA2500 Active Probe (Model 701913). This user’s manual contains useful information about the functions and operating procedures of the PBA2500 Active Probe and lists the handling precautions of the instrument. To ensure correct use, please read this manual thoroughly before beginning operation. -
Page 3: Checking The Contents Of The Package
Checking the Contents of the Package If any of the contents are incorrect, missing, or appear to be abnormal, please contact your Yokogawa dealer or representative. PBA2500 Active Probe: 1 Various kinds of attachments (see page 1-2) •... -
Page 4: Safety Symbols And Precautions
To ensure safe and correct operation of the instrument, you must take the safety precautions given on the next page. The instrument may not function if used in a manner not described in this manual. Yokogawa bears no responsibility for, nor implies any warranty against damages occurring as a result of failure to take these precautions. -
Page 5: Safety Precautions
Inspect the probe before use to ensure that damage has not occurred during shipping and storing. If damage is found, contact your nearest Yokogawa dealer or sales representative. • This probe is not water or dust resistant. Do not use the probe in areas with a lot of dust, or near water. -
Page 6: Table Of Contents
Foreword ....................i Checking the Contents of the Package ............ ii Safety Symbols and Precautions ............iii Safety Precautions .................. iv Product Overview ..................1 Features ....................1 Names of Parts ..................2 Operating Procedures ................3 Product Specifications ................5 IM 701913-01E... -
Page 7: Product Overview
• Power can be supplied to the probe from the DL9000 series instrument. • The probe is automatically recognized by the DL9000 series instrument. • The attachment that touches the circuit under test can be changed • Compact and lightweight IM 701913-01E... -
Page 8: Names Of Parts
The probe’s input terminals. An attachment is selected according to the circuit to be tested, and attached to the probe head. Output terminal The output terminal is a BNC connector. It connects to the input of the oscilloscope (BNC connector). IM 701913-01E... -
Page 9: Operating Procedures
When measuring signals including frequencies of 100 MHz and higher in particular, we recommend that you use as short of an attachment as possible to connect the circuit under test to the probe head (both signal input terminal and ground terminal). IM 701913-01E... - Page 10 • After connecting the probe, heat emitted from the probe itself causes the offset voltage to drift. The probe should nearly stabilize about thirty minutes after applying power. • The offset voltage drifts as a result of the ambient temperature. During continuous use, make sure the ambient temperature is stable. IM 701913-01E...
-
Page 11: Product Specifications
140 ps or less (not including characteristics of the oscilloscope, typical value Residual noise 300 µVrms or less (in probe output, typical value Residual offset Within ±2 m Derating of the input voltage by frequency (V peak) 1000 2500 Frequency (MHz) IM 701913-01E... - Page 12 *4 Typical value represents a typical or average value. It is not strictly guaranteed. *5 No condensation *6 Test conditions Frequency bandwidth limit of 20 MHz, using a DL9000 series digital oscilloscope set for an input impedance of 50 Ω, and probe tip terminated at 50 Ω. IM 701913-01E...
Need help?
Do you have a question about the 701913 and is the answer not in the manual?
Questions and answers