Speaker Placement - Kenwood 1080VR Instruction Manual

1080VR [En/Kj
Mp BRO
Speaker placement.
—
Front speakers : Place to the front left and right of the listening position. Front
: speakers are required for all surround modes.
; cil Center speaker : Place front and center. This speaker stabilizes the sound+mage
r and heips recreate sound motion. Be sure to connect a center speaker when
{
i |
Q using the Dolby 3 Stereo mode.
neal listening position at even heights, approximately 1 meter above the ears of
\ 1 aces |
Center speaker
Surround speakers : Place to the direct left and right, or slightly behind, the
the listeners. These speakers recreate sound motion and atmosphere.
Required for surround playback.
Subwoofer : Reproduces powerful deep bass sounds.
: Subwoofer
N Front speaker
Listening position ',
\ | Although the idea! surround system consists of all the speakers listed above, if you don't
:
y have a center speaker or a subwoofer, you can divide those signals between the available
speakers in the following steps to obtain the best possible surround reproduction from the
speakers you have available.
2 | Go to the SP.SLCT (speaker select) page of the SET UP screen.
¢ Pressing the MAIN icon lets you access
the main sound menu. -33
SETUP
Ej Select the speakers and enter the speaker distance.
© Specify the type of speakers you connected to the receiver.
Move the pointer downward (icon turns blue).
Use the TUNING/SKIP keys to specify the setting you desire.
Press the BAND (p/#1) key to confirm the setting (icon turns yellow}.
Repeat steps 2: and 3: to specify a setting for each speaker type.
¢ Be sure to specify settings for each speaker type before continuing to the next
screen.
SW : Subwoofer
ON: Select when using a subwoofer.
OFF: Select when not using a subwoofer.
LR: Front speakers (left and right)
SML (small}: Select when using a relatively small front speakers.
LRG (large): Select when using a relatively large front speakers.
C : Center speaker
SML (small): Select when using a relatively small center speaker.
LRG (large): Select when using a relatively large center speaker.
OFF: Select when not using a center speaker.
S : Surround speakers (left and right)
SML (small): Select when using a relatively small surround speaker.
LRG {large}: Select when using a relatively large surround speaker.
OFF: Select when not using surround speakers.
Bowin =
| [| SETUP
© Continue to the SP.LVL (speaker level) screen.