Table of Contents
Advertisement
Remote control unit
The backlight flashes five times during nor-
mal operation.
Subwoofer volume cannot be adjusted.
Certain inputs cannot
be selected using
the remote control.
Remote control operation is not possible.
Note
For the
U.S.A.
FCC WARNING
change or modification 1s made.
NOTE:
The batteries are nearing exhaustion.
Subwoofer is OFF.
No preset codes registered at for the respec-
tive input(s).
The remote control is set to a different opera-
tion mode.
Batteries are exhausted.
The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
The audio cords and system control cords are
not connected properly.
No software is loaded in the source compo-
nent.
An attempt is made to play a tape which is
being recorded in the cassette deck.
tallation. This equipment may cause harmful
10B0VR (En/K}
Replace with new
batteries to preserve the
currently registered setup information.—2@.
Turn the subwoofer ON.
Register a preset code or Non-iR code at the
respective input(s).
36
Press VIDEO,
AUDIO,
or TV to select the
approriate operation mode.
Replace with new batteries. If the backup-is
exhasted before you can replace the batter-
ies, redo the setup procedure.
—2i4
~ 36
Operate the remote control unit within the
controllable range.
Connect properly referring to "Setting up the
system".
-=
Place software in the source component you
want to play.
Wait until recording has completed.
Press the VIDEO, AUDIO, or TV key to activate
the operation
mode
for the component
you
want to control before operation.
- (32,
y careful against using contact cleaning agents
Memory back up function
the AC outlet for approximately 3 days.
pe Power mode
* Settings made using OSD (like SURROUND
SET UP)
* Input selector settings
* Volume ievel
© Broadcast band.
le Frequency setting.
* Preset stations.
For the U.S.A.
Note to CATV system installer:
Advertisement
Table of Contents
