Setting Up Speakers; Speaker Placement; Speaker Selection - Kenwood KRF-X7775D Connection And Setup Manual

Chapter Two : Setting Up Remote Control Unit
Before you can begin using the receiver to control your home
entertainment system, you must set up Remote Control unit
to operate your speakers effectively. There are four areas of
speaker setup:
• SP Selection
• SP Level
• Bass Prek Level
• SP Distance
The receiver must be on and speakers must be connected
before you can set up speakers.

Speaker Placement:

An example of installation is shown here.
Use this figure as a reference for installing the system ac-
cording to the types of your speakers and conditions of your
listening room.
C
36 FL FR
SW
SL
SBL SBR
FL/FR (Front speakers) : Place to the front left and right
of the listening position. Front speakers are required for all
surround modes.
C (Center speaker) : Place front and center. This speaker
stabilizes the sound image and helps recreate sound mo-
tion.
SW (Subwoofer) : Reproduces powerful deep bass sounds.
SL/SR (Surround speakers) : Place to the direct left and
right, or slightly behind, the listening position at even
heights, approximately 1 meter above the ears of the listen-
ers.

Setting Up Speakers

SBL/SBR (Surround back speakers) : The SBL/SBR
speakers are required to reproduce the 6.1-channel signals.
Place them on the left and right behind the listening posi-
tion and at a height slightly higher than the SL/SR speak-
ers.

Speaker Selection:

1. Press the POWER ON/STANDBY button on the main
unit to turn the power on.
2. Press the MUSIC button or MOVIE button to display
the "Menu".
SR
3. Press the Menu button (LCD function button 2).
4. Press the Setup button (LCD function button 2).
5. Press the LCD cursor up/down button (
6. Press the LCD cursor up/down button (
REC
7. When the front (left and right) speaker setting menu
lect "02. Surround", then press the Enter button (LCD
function button 2)
REC
lect Sub Woofer On or Off, then press the Next button
(LCD function button 2).
• If you selected On for the subwoofer, all of the bass
below 80Hz is removed from all other Nml (Normal)/
THX setting speakers in your system and is sent to
the subwoofer in all listening modes. This improves
your speakers' power handling and reduces overall dis-
tortion.
• If you selected Off for the subwoofer, the bass tone
is removed from all other Nml/THX setting speakers
in your system and is sent to the front L and R speakers.
Select Nml/THX for the speaker for use in THX re-
production.
(Front) appears, select Front Nml (Normal)/THX or
Large in the same way as step 6, then press the Next
button. (If you set the subwoofer to Off in step 6, skip
this step.)
, ) to se-
, ) to se-