Removing Packaging Reinforcement; Connecting Water Supply - Smeg SW107D Manual

kilograms. Place the product on a solid and flat
floor that has sufficient load carrying capacity!
edges of other furniture.

Removing packaging reinforcement

packaging reinforcement. Remove the packaging
Removing the transportation locks
A
taking out the packaging reinforcement.
A
operating the washing machine, otherwise, the
rotate freely (C).
them gently.
C
place to reuse when the washing machine
C
Never move the product without the
place!

Connecting water supply

C
water flowing from the fully open tap in one
minute to have your machine run smoothly.
Attach a pressure reducing valve if water
pressure is higher.
C
must install the supplied stopper to the hot
stopper group.)
C
product, connect the hot water hose after
removing the stopper and gasket group from
the hot water valve. (Applies for the products
A
the laundry will get damaged or the product will
switch to protection mode and will not operate.
A
laundry.
product to the water inlets on the product. Red
inlet.
A
Ensure that the cold and hot water connections
are made correctly when installing the product.
end of the washing process and wear out.
wrench when tightening the nuts.
connection to check for water leaks at the
the tap and remove the nut. Retighten the nut
carefully after checking the seal. To prevent
keep the taps closed when the machine is not
in use.
Connecting to the drain
connected to the wastewater drain or to the
A
out of its housing during water discharge.
Moreover, there is risk of scalding due to
high washing temperatures! To prevent such
situations and to ensure smooth water intake
and discharge of the machine, fix the end of the
discharge hose tightly so that it cannot come
out.
floor level or close to the ground (less than
come out excessively wet. Therefore, follow the
3
EN