Related Manuals for Smeg STA120
Summary of Contents for Smeg STA120
- Page 1 LAVABIANCHERIA WASHING MACHINE LAVE-LINGE WASCHMASCHINE LAVADORA WASAUTOMAAT LIBRETTO ISTRUZIONI INSTRUCTIONS MANUAL MANUEL D’INSTRUCTIONS GEBRAUCHSANWEISUNG MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING...
-
Page 2: The New Washing System
Washing times have also been reduced. Pre-washing is only recommended for very dirty laundry. Please read the operating instructions with care in order to take full advantage of all the features offered by this washing machine. Warning! Please read all the instructions contained in this manual in order to understand how to operate this appliance correctly and safely. -
Page 3: Safety Warnings
Make sure that the drain hose is securely attached to the basin and cannot move. If it is not securely fitted, the repulsive force of the water may detach it from the basin and cause flood- ing. When attaching the hose to the basin, make sure the water drains away rapidly and does not fill the basin up. - Page 4 Before removing laundry from the washing machine, make sure the drum has stopped moving. Always switch off the appliance after use to avoid wasting electricity. Leave the door ajar between one wash and the next in order to keep the gasket in good condition. Prolonged inactivity.
-
Page 5: Installation Instructions
Do not turn the machine upside down and do not place it on its side. • Keep all the components used to block the drum assembly as they will be needed if you decide to move the appliance in future. -
Page 6: Drain Connection
3.4 DRAIN CONNECTION 1. Insert the end of the drain hose into a drain pipe having an internal diameter of at least 4 cm and a height rang- ing between 50 and 90 cm, or attach it (using the relative curved plastic profile) to a basin or bath tub. -
Page 7: Description Of Controls
4. DESCRIPTION OF CONTROLS 4.1 CONTROL PANEL All the commands and controls of the appliance are assembled together on the front panel. Models with fixed spin speed Models with spin speed selector Description of controls Open door button ON-OFF and programme selection knob... - Page 8 Open door button Press the button to open the door. Chapter 5 – Washing in- structions – explains how the door works and how to use it. ON-OFF and washing pro- This knob lets you: gramme selection knob • switch the machine on and off by moving it in either...
- Page 9 This button reduces the overall duration of the washing cycle. This Quick wash Button option is used to wash small loads or less dirty washing in less time. The bleach stage is skipped when the Quick Wash button is pressed (for models with bleach function).
- Page 10 (max. speed) (intermediate speed) For models with spin speed selector 4.2 DETERGENT TRAY This is located to the left of the control panel. Pull it out to open. The tray comprises four compartments which are marked as follows “1”: pre-wash detergent “2”: main wash detergent...
-
Page 11: Using The Machine
Before opening the door, wait 1 or 2 minutes after the programme ends (“End” LED on) to allow the safety device to disengage. Make sure there is no water in the tub and that the drum is not moving. Open the door by pressing the “Open door” button on the front panel and pulling it open. -
Page 12: Loading The Washing
5.3 PREPARING THE WASHING Where possible, save electricity by washing full loads divided by type of fabric. Introduce loose washing and alternate large items with small ones. For the first few times, weigh the loads of washing and then rely on your judgement. - Page 13 Pour the total quantity of detergent indicated on the packs into compartment “2” of the detergent tray. Very dirty washing Choose a programme with prewash. Add ¼ of the recommended quantity of detergent into compartment “1” of the detergent tray and ¾ of the de- tergent into compartment “2”. Attention! •...
-
Page 14: Speed Selection
Press the button identified with the letter “H” in chapter 4 – Description of controls, the 3 LED's located over the button light up in sequence to indicate (from top to bottom): •... -
Page 15: Starting The Washing Programme
5.11 SELECTION OF OPTIONS Use the options buttons (indicated in chapter 4 – Description of controls) to enable machine options. A selected option is highlighted by the option LED located above the button in question. 5.12 STARTING THE WASHING PROGRAMME Before starting the selected programme, carefully close the door, open the water tap and add the deter- gent and additive. -
Page 16: Cleaning And Maintenance
Periodically check that no clips, buttons, nails or needles have got caught in the folds of the door gasket. 6.4 CLEANING THE DRAIN PUMP Only clean the drain pump if it is obstructed by buttons, hairpins and the like and the water cannot drain. In this case, proceed as follows. -
Page 17: Cleaning The Water Inlet Filter
MODEL A – Insert the lower part of the cover first. Then secure it by turning the plastic buttons a quarter turn clockwise. The slots in the buttons must be horizontal. MODEL B – Insert the lower part of the cover first and then push it towards the base plate until it clicks into place. 6.5 CLEANING THE DETERGENT TRAY Keep the detergent tray free from scale. -
Page 18: Troubleshooting
7. TROUBLESHOOTING This product complies with current safety regulations governing electrical equipment. For safety reasons, all tech- nical inspections or repairs must be performed by qualified technicians in order to prevent hazardous situations for users. If the machine does not work, before calling the Service Centre and spending money unnecessarily, check that the operations indicated in this troubleshooting table have been performed. -
Page 19: Error Signals
The “End” LED flashes for about half a second and then goes off for the same amount of time before flashing again. While the “End” LED flashes, the LED's located above the options button flash but do so more rapidly. To determine the type of error, count the number of times the “End”... - Page 20 Prewash at 35°C, wash at 90°C, rinses and final spin at 600 rpm 90° Rinses ○ ○ ○ 3 or 4 rinses (if the extra rinse button is pressed) and final spin at 600 rpm 0° ○ ○ Drain and spin Just drain, or drain and final spin at 600 rpm 0°...
- Page 21 Wash at 40°C, rinses, drain and spin at selected speed (max. 900 rpm) Very dirty resistant synthetics 60° 2,5 ○ ○ Prewash at 35°C, wash at 60°C, rinses, drain and spin at selected speed (max. 900 rpm) ○ ○ Normally dirty resistant synthetics 60° 2,5 Wash at 60°C, rinses, drain and spin at selected speed (max.