Maintenance And Cleaning - Smeg SW107D Manual

door opening, then turn the Programme
and discharge the water in the machine.
Machine is in Rinse Hold mode
is in this mode:
discharges the water and spins the laundry.
spinning:
Programme resumes and discharges the water
only.
End of programme
"End" appears on the display at the end of the
remain lit. Auxiliary function, spin speed and
the programme remain selected.

5 Maintenance and cleaning

intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals
in order to prevent accumulation of powder
detergent in time.
Press the dotted point on the siphon in the
softener compartment and pull towards you until
the compartment is removed from the machine.
C
softener mixture starts to gather in the
cleaned.
Wash the detergent drawer and the siphon with
avoid touching of the residues in the drawer with
into its place after cleaning and make sure that it is
seated well.
Cleaning the water intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at the
end of each water intake hose where they are
connected to the tap. These filters prevent foreign
they do get dirty.
Close the taps. Remove the nuts of the water
intake hoses to access the filters on the water
intake valves. Clean them with an appropriate
filters on the flat ends of the water intake hoses
together with the gaskets and clean thoroughly
under running water. Replace the gaskets and
filters carefully in their places and tighten the hose
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
clogging the pump impeller during discharge of
pump will extend.
drained off first to clean the pump filter.
(eg., when moving to another house) and in case
drained completely.
A
damage your machine or may cause noise
water:
A
Temperature of the water inside the machine
machine cools down.
EN