Sw-1705 Board - Sony SUPER MOTION HDC-P43 Service Manual

4-17.

SW-1705 Board

Preparation
1. Remove the side panel (L), side panel (R) and bottom cover. (Refer to
2. Remove the DPR-376 board. (Refer to
3. Remove the front assembly. (Refer to
4. Remove the PS-921 board. (Refer to
5. Remove the rear panel assembly. (Refer to
6. Remove the DC fan block assembly. (Refer to
Procedure
1. Remove the SW-1705 board.
(1) Release the harness from the clamper.
(2) Remove the two connector screws (M2.6 x 5) and the encoder knob.
(3) Remove the four screws (PSW2 x 5), and then remove the SW-1705 board.
(4) Remove the SW cap and the clamper.
Note
Be careful not to lose the SW cap.
Harness (XLR)
SW cap
HDC-P43
"4-5. DPR-376 Board")
"4-6. Front Panel Assembly")
"4-11. PS-921 Board")
"4-12. Rear Panel
"4-13. DC
PSW2 x 5
Clamper
Hole
Boss
Connector screws
(M2.6 x 5)
"4-4. Side Panel, Bottom
Assembly")
Fan")
Hole
SW-1705 board
Bosses
Encoder knob
Cover")
4-27