Preparation/Mounting - Dual DCPA1013 Installation & Owner's Manual

DCPA1013
Installation Guide
Step #1
Install Mounting Sleeve and Trim Ring
1) Install the mounting sleeve into a dash kit (sold separately) or dash
opening, bending the tabs to secure the mounting sleeve.
2) Connect the wiring harness, microphone and antenna to the chassis
of the radio.
3) Snap trim ring into place making sure the notched area is on the
bottom.
4) Slide the receiver into the mounting sleeve to secure.
Step #1
Installing the 2-DIN Chassis Sleeve
Attach the 2-DIN chassis sleeve using (4) M2.5*4 screws
Install the 2-DIN mounting chassis sleeve to the top of the
chassis (shown above) or to the bottom of the chassis (shown below).
5
Preparation
Preparing for Installation
Package Contents
1.Main Unit
2.Mounting Sleeve for 1 DIN
3.Release Keys
4.Screw Kit
5.Chassis sleeve for 2 DIN install
1
4
Mounting Screw for 2DIN Bracket M2.5*4 5PCS
Flat Head Screw M5*6 8pcs
Round Head Screw M5*6 8pcs
7
Connecting the LCD to the Chassis
To connect the LCD to the unit, carefully push the LCD
connector into the receiver's chassis until you hear a click
as shown below.
Install Mounting Side Brackets
Mounting brackets shown below or optional
vehicle mounting kit are not included
2-DIN Chassis Sleeve
A
OR
B
6.Trim Ring
7.Wiring Harness
8.Microphone
9.GPS Antenna (for CarPlay
and Android Auto only)
2 3
5 6
8 9
Step #2
Step #2
Install the mounting brackets to the chassis of the
radio or to the 2-DIN chassis sleeve depending on
choice of mounting option as shown in Step #1 to the left.
Installation
Before You Begin
Before You Begin
• Consult a qualified technician for instructions.
We always recommend professional installation.
• Disconnect the negative battery terminal.
• Remove trim ring from unit (if installed).
• Insert the removal keys, and remove the mounting sleeve
from the receiver.
Note: Most vehicles require an installation kit, wiring
harness and/or antenna adapter (all sold separately)
to properly install the head unit in the vehicle.
Removing the LCD from the Chassis
1. Hold down the two release buttons
2. Gently pull the display panel forward
Step #3
Installation Complete