Mounting; Ventilation; Hob Seal - Smeg SI0644X Manual

Instructions for the installer

8.3 Mounting

The distance between the induction hob and the kitchen furniture or other built in appliances must be
enough to ensure sufficient ventilation and air discharge.
Remove the front transverse strip (if necessary) on the unit to create an opening for the air flow of at
least 4 mm under the work surface across the full width of the appliance.
In any event, if installed above an oven, a dishwasher or a refrigerator, a space of at least 5 cm must be
left between the hob and the top of the appliance installed below.
opens only on bottom opens on bottom and on rear

8.4 Ventilation

The illustrations below show two examples of installation suitable for proper ventilation and one example
of incorrect installation to be avoided.
Do not obstruct the ventilation grille in front of the product in any type of installation.

8.5 Hob seal

To prevent leakage of liquid between the frame of
the hob and the work surface, place the seal
provided along the entire outer edge of the hob
before assembly.
Do not fix the hob using silicon as this would make it impossible to uninstall the hob, if necessary, without
damaging it.
36