Technical Data; Safety Rules - Hilti PMC 36 Manual

Self-leveling combilaser
Hide thumbs Also See for PMC 36:
Table of Contents

Advertisement

4. Technical data

NOTE
Right of technical changes reserved.
Range of the points
Range of the lines and intersection point
Accuracy of the points
Accuracy of the laser lines
Self-leveling time
Laser class
Beam diameter (lower beam)
Beam diameter (other beams)
Line width
Self-leveling range
Automatic power-off
Operating status indicator
Power supply
Battery life (2 points and 1 line)
Operating temperature range
Storage temperature
Dust and water spray protection (except battery
compartment)
Tripod thread
Weight
Dimensions

5. Safety rules

In addition to the information relevant to safety
given in each of the sections of these operating
instructions, the following points must be strictly
observed at all times.
5.1 General safety rules
a) Check the accuracy of the tool before using it to
take measurements.
b) The tool and its ancillary equipment may present
hazards when used incorrectly by untrained per-
sonnel or when used not as directed.
30 m
10 m
Distance 10 m (30 ft): ±3 mm (±¹/₈ in)
Length of the lines 10 m (30 ft): ±1.5 mm (±¹/₁₆ in)
5 s
Class 3R: EN 60825‑01:2003; IEC 825‑ 1:2003;
Class IIIa: CFR 21 § 1040 (FDA)
Distance 5 m: < 5 mm
Distance 20 m: < 20 mm
Distance 5 m: < 4 mm
Distance 20 m: < 16 mm
Distance 5 m: < 2.2 mm
±3.5°
Activated after: 15 min
LED and laser beams
AA‑size batteries, Alkaline batteries: 4
Alkaline battery 2,500 mAh, Temperature 25°C
(+77°F): 40 h
Min. ‑10°C / Max. 50°C (+14 to 122°F)
Min. ‑20°C / Max. 63°C (-4 to 145°F)
IP 54
IEC 529
BSW⁵⁄₈"UNC¹⁄₄"
Without batteries: 0.66 kg
Foot in the closed position: 138 mm X 51 mm X
89 mm
Foot in the open position: 164 mm X 51 mm X
126 mm
c) To avoid the risk of injury, use only genuine Hilti
accessories and additional equipment.
d) Do not open the casing of the tool.
e) Modification of the tool is not permissible.
f) Observe the information printed in the operat-
ing instructions concerning operation, care and
maintenance.
g) Do not render safety devices ineffective and do
not remove information and warning notices.
h) Keep laser tools out of reach of children.
en
17

Advertisement

Table of Contents
loading

Table of Contents