Selecting A Function - Smeg SC106-2 Instructions Manual

Instructions for the user
7.4 Operating modes
This product is programmed to have 2 operating conditions:
7.5 Adjusting the clock
At first use, or after a power failure, the oven's display (DSP) will show a
flashing symbol. To be able to start any cooking function the current
time must be set.
To adjust the time keep PT1 turned to the
increase (+ decrease (-
) or

Selecting a function

7.6
To select a cooking function, turn PT2: the preset cooking temperature will
be displayed on the DSP.
7.6.1 Cooking with preset temperature
Once the desired function has been selected, the oven will begin cooking
at the pre-set time. Cooking itself is preceded by a preheating stage,
which allows the oven to heat to the cooking temperature more quickly.
This phase is indicated by the symbol
the preheating stage is over, the
buzzer will sound to indicate that the food can be placed inside the oven.
In multifunction models the function
of 30°C, or proving at 40°C.
7.6.2 Changing the preset temperature
The temperature preset for each function can be changed to suit the user's
requirements.
At any time while cooking is in progress, turn PT1 to increase or decrease
the cooking temperature by 5 degrees at a time. (PT1 can also be held in
the left or right position to increase or decrease the setting more quickly).
Stand-by setting: this condition is set
when the knob PT2 is positioned on the
"0" symbol and the current time
appears on the display.
ON setting: this condition is set when
the selection knob PT2 is turned to any
function and the selected temperature
appears on the display, or the message
"PYro" if in pyrolysis.
right or to the left in order to
) the value.
flashing on the display (DSP). When
symbol will remain constantly on and a
allows thawing by selecting a temperature
49