Rear Panel Leds - Cisco 1600 Hardware Installation Manual

Overview
11
13

Rear Panel LEDs

The following figure shows the rear panel LEDs and describes their states.
Figure 9: Rear Panel LEDs and Their States
1
3
Threaded holes for dual-hole grounding lug
eth3 management interface
(Optional) 10-Gigabit Ethernet SFP+ support
SFP-10G-SR and SFP-10G-LR are qualified for
use on the FMC.
100-Mbps/1-Gbps/10-Gbps Ethernet link (speed
on both LAN1 and LAN2):
• Off—Link speed is 100 Mbps.
• Amber—Link speed is 1 Gbps.
• Green—Link speed is 10 Gbps.
1-Gbps Ethernet dedicated management link:
• Off—Link speed is 10 Mbps.
• Amber—Link speed is 100 Gbps.
• Green—Link speed is 1 Gbps.
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
12 eth2 management interface
(Optional) 10-Gigabit Ethernet SFP+ support
SFP-10G-SR and SFP-10G-LR are qualified for
use on the FMC.
Riser handle
14
Not supported
2 100-Mbps/1-Gbps/10-Gbps Ethernet link status
(speed on both LAN1 and LAN2):
• Off—No link is present.
• Green—Link is active.
• Green, flashing—Traffic is present on the
active link.
4 1-Gbps Ethernet dedicated management link:
• Off—No link is present.
• Amber—Link is active.
• Green, flashing—Traffic is present on the
active link.
Rear Panel LEDs
13