Troubleshooting Minor Problems - Smeg PL614WH Instruction Manual

TROUBLESHOOTING MINOR PROBLEMS

In some cases it is possible to remedy minor problems by referring to the following instructions:
If the program fails to start, check that:
•
•
•
•
If water remains inside the dishwasher, check that:
•
•
•
If the dishes are not being cleaned properly, check that:
•
•
•
•
•
•
•
If the dishes fail to dry or remain dull, check that:
•
•
•
If the dishes show signs of streaking, staining, etc., check that:
•
If there are visible traces of rust inside the tank:
•
•
•
If after following the above troubleshooting instructions the problem persists, call the nearest After-
Sales Centre.
WARNING: any operations performed on the appliance by unauthorised persons are not
covered by the warranty and shall be paid for by the user.
24
User instructions
the dishwasher is connected to the electrical power supply;
there is no power failure;
the water tap is open;
the dishwasher door is properly closed.
the drain hose is not kinked;
the drain siphon is not obstructed;
the dishwasher filters are not clogged.
the correct amount of detergent has been added;
there is regenerating salt inside the special container;
the dishes are being loaded correctly;
the selected program is suitable for the dish types and their degree of soiling;
all the filters are clean and positioned correctly;
the spray arm nozzles are not obstructed;
there is no object obstructing the rotation of the spray arms.
there is rinse aid inside the special container;
the rinse aid dispenser setting is correct;
the detergent used is of good quality and has not lost its effectiveness (for example, through
incorrect storage, with the box left open).
the rinse aid dispenser setting is not too high.
the tank is made of steel, and therefore any rust marks are due to external elements
(fragments of rust from the water pipes, pots, cutlery, etc.). Special products are commercially
available t o remove such marks;
check that the amount of detergent being used is correct. Certain detergents can be more
corrosive than others.
check that the cap of the salt container is securely closed, and that the water softening setting
is correct.