Smeg PL614WH Instruction Manual page 12

User instructions
DELAY PROGRAM (on some models only)
Pressing button DELAY PROGRAM (3) in sequence delays the start of the program by 3, 6 or 9
hours. This allows you to set the dishwasher to work at specific times of day.
After selecting the delay, start the program in the normal way (see relative section).
The appliance will prewash the dishes, after which the "delay program" set previously will come into
effect (the phase lights switch off and the light relating to the delay set flashes).
To reset or change the delay once the program has started:
•
press the START/PAUSE button (5) for a few seconds, until the PROGRAM PHASES lights
(10) come on;
•
press the DELAY PROGRAM button (3) several times "until the program delay" returns to zero
(all the lights indicating the delay go out);
•
press the START/PAUSE button (5) to start the new program.
To set the delay once the program has started, proceed as follows.
If the program you wish to carry out is the same as the one already in progress:
• press the START/PAUSE button (5) for a few seconds, until the PROGRAM PHASES lights
(10) come on;
•
annul the program in progress (see relative section) and wait for the cycle to come to an end;
• select the program again;
•
select the delay required;
•
press the START/PAUSE button (5) to start the new program.
If the program you wish to carry out is different from the one already in progress:
•
press the START/PAUSE button (5) for a few seconds, until the PROGRAM PHASES lights
(10) come on;
•
change the program;
•
select the delay required;
•
press the START/PAUSE button (5) to start the new program. The dishwahser will pump out
the water and restart with the delay set and the new program.
TO SAVE ON ENERGY! ... AND PROTECT THE ENVIRONMENT
Always try to run the dishwasher fully loaded .
•
Do not wash the dishes in running water.
•
Use the washing program that is most appropriate for each type of load.
•
Do not carry out any preliminary rinsing.
•
If available, connect the dishwasher to a hot water supply up to 60°C.
•
When possible, skip the drying cycle by leaving the door open when the washing cycle is
•
complete; the air and the residual heat will dry the dishes perfectly.
TO CUT DOWN ON DETERGENT CONSUMPTION! ... AND PROTECT THE ENVIRONMENT
The phosphates contained in dishwasher detergents are harmful to the environment. To avoid
using excessive amounts of detergent and to save on electricity, observe the following:
separate the more delicate items from dishes that are more resistant to aggressive detergents
•
and high temperatures;
do not pour the detergent directly on the dishes.
•
REMOVING THE DISHES
The door can be opened at the end of cycle approximately 50mm for improved drying
performance. At the end of the washing program, wait at least 20 minutes before removing the
dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling
on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the
upper basket.
13