Cleaning The Filter Unit - Smeg PL614WH Instruction Manual

User instructions

CLEANING THE FILTER UNIT

It is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove
•
the filter, grip the tabs, turn them anticlockwise and lift upwards;
push the centre filter D from the underside to remove it from the micro-filter:
•
separate the two parts which make up the plastic filter by pressing the body of the filter in the
•
zone shown by the arrows;
remove the centre filter by lifting it upwards.
•
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE:
The filters should be cleaned under running water using a stiff brush.
•
It is essential to thoroughly clean the filters according to the above instructions: the
•
dishwasher cannot function if the filters are clogged.
Carefully replace the filters in their seats, to avoid damaging the wash pump.
•
PROLONGED DISUSE:
Run the soak program twice in succession.
•
Unplug the power cord from the socket.
•
Leave the door slightly open , in order to prevent the formation of unpleasant odours inside
•
the washing tank.
Fill the rinse aid dispenser .
•
Shut off the water supply tap.
•
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:
Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the
•
water to run from the water supply tap for a few minutes.
Plug the power cord back into the socket.
•
• Reconnect the water intake hose and open the tap again.
23