Mounting Onto Furniture - Smeg PGF31GBE1 Manual

7. MOUNTING ONTO FURNITURE

This appliance belongs to Class 3 (built in)
The following operation requires building and/or carpentry work and must
therefore be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry, metal,
solid wood or plastic laminated wood as long as they are heat resistant (T 90°C).
7.1 Fixing to the supporting structure
Create an opening with the dimensions shown in the figure in the top surface of
the counter, keeping a minimum distance of 50 mm from the rear edge. This
appliance can be mounted against walls higher than the work surface on
condition that a distance be kept between the appliance and the wall as shown
in the figure so as to avoid damage from overheating. Make sure there is a
minimum distance of 750 mm between the hob burners and any shelf or hood
that may be installed directly above it.
7.2 Hob seal
Carefully position the supplied insulating seal on
the outer perimeter of the hole made in the counter
top as shown in the adjacent figure, trying to make
it stick on the entire surface by applying light
pressure on it with your hands.
The seal must be placed at a distance of 3-4 mm
from the external perimeter of the hole made in the
counter top.
Do not fix the hob using silicone as this would make it impossible to remove the
hob, if necessary, without damaging it.
14
Instructions for the installer
m m
3 - 4