Water Inlet Connection - Smeg LB86-1 Instructions For Use Manual

Water inlet connection

Water inlet connection
6
• If you have a tumble dryer of the same dimensions, you can
place it on top of the washing machine.
To ensure correct operation of the appliance, water
pressure inlet must be between 0,05 and 0,8 MPa.
Minimum water pressure can be established by measuring
the quantity of poured out water. 3 litres of water must be
poured out from completely opened tap in 15 seconds.
• Take the water inlet hose from the drum and attach the inlet
hose angle extension (1) to the washing machine by screwing
it onto the provided thread (certain models only).
• Insert the gasket with a fi lter net into the straight inlet hose
attachment nut (2) and screw the nut onto the water tap. (With
some models, the gasket with fi lter net is already fi tted and
any additional fi tting into the nut on the straight attachment is
not required).
• In case of hot and cold water connection, connect one hose to
cold and other to hot water faucet as marked at the rear of the
appliance (letters C and H) (C - cold; H - hot)
The inlet hose should be tightened manually, fi rmly
enough to prevent any leaks. After tightening the hose,
check for any leaks.
Use of pliers, wrenches, or other similar tools is not
allowed when installing the hose, as these tools can
damage the nut thread.
Partial Aqua-stop (water stop system)
In case of damage on the interior pipe, leaking is prevented by
automatic closing system which stops water inlet to the machine.
In such cases display A turns red.
Inlet pipe must be replaced.
Complete Aqua-stop (certain models only)
In case of damage on the interior pipe, leaking is prevented by
automatic closing system which stops water inlet to the machine.
Security system also detects whether there is any water leakage
within the interior of the machine. In such cases washing is
suspended, machine switches on the pump and signals error.