Smeg LB86-1 Instructions For Use Manual page 12

12
Pump stop
• This function is switched on after the selection of a basic
program by pressing the knob (E). It may also be switched on
during the operation, prior last rinse. Indicator LED above the
washing cycle symbol is lit.
• The program stops at the end of last rinse, prior spinning:
laundry remains soaked in water and prevents crease, if you
are unable to remove it from the drum immediately after the end
of washing cycle.
• Indicator LED above the knob is fl ashing.
The selected program is completed by pushing the START
button (F), but you may also apply partial programs (pumping or
spinning), but you must fi rst return the program selector (A) to
the "0" position for at least one second, prior selecting any of the
partial programs.
When program continues, indicator LED above the knob goes
off.
- Selection of partial programs (
These are independent programs and may be used when you do
not need the entire washing program. In case you would like to
use more additional programs in a sequence, you must turn off
the appliance prior any new program selection (turn the program
selector to "0" for at least one second).
Rinse
Independent program for rinsing delicate laundry, without
intermediate spinning and with short fi nal spin. You may use
it for rinsing manually washed delicate laundry.
You may engage the reduced spin RPM knob.
Softening
This program is intended for softening, bleaching or
impregnating of washed laundry. It is completed with
aggressive spinning at high RPM.
You may engage the reduced spin RPM knob.
Pumping the water out
Use it when the washing program was interrupted or if pump stop
function was engaged, and you only wish to pump the water out
of the drum, without spinning.
Spinning
Aggressive spinning for non-delicate laundry at high spin RMP.
You may engage the reduced spin RPM knob.
, , , )