Smeg LB86-1 Instructions For Use Manual page 7

Water outlet connection Water outlet connection
Connect the appliance to Connect the appliance to
the mains supply the mains supply
Do not immerse the Aqua-stop system inlet pipe into
the water, because it contains the electric valve!
• Fix the outlet hose to run into the sink or the bathtub, or connect
it directly to the wall drain outlet (diameter min. 4 cm).
• Wall drain must be installed properly and must enable
occasional cleaning.
• Fasten the outlet hose support with a piece of rope led through
the hose elbow, to prevent the hose from slipping to the fl oor.
The end of outlet hose should be placed between minimum 60
cm and maximum 100 cm above the fl oor level.
• Plug the mains power cable to the wall mains socket.
• Required voltage and other information are written on the rating
plate above the door opening of the machine.
The wall socket must be accessible at all times and
must be equipped with an earth lead (in accordance
with the local safety regulations).
The permanent connection must be fi tted by an
authorized personnel only.
Damaged mains power cable may be replaced only by
the producer or his authorized personnel.
Never plug the appliance into the electric shaver socket
or hair dryer socket.
7