Smeg LB86-1 Instructions For Use Manual page 22

Failure
FAILURE 5
Motor operation interrupted;
or motor does not operate
(the machine reports
a failure - the LEDs
periodically fl ash fi ve times)
FAILURE 6
Program temperature not
reached (the machine
reports a failure - the LEDs
periodically fl ash six times)
* UKS: universal stability control - this function prevents excessive vibrations during spinning.
22
Possible cause
Motor overload or motor failure. • Turn off the appliance and wait for
• Heater failure
• Inlet water too cold
• Manual addition of water
In case you were not successful in repairing the malfunctions in
spite of the above suggestion chart, call the nearest authorized
service shop.
Repairing the failure arising from inappropriate connections or
use of the appliance is not covered by the guarantee, and the
repair expenses are paid by the customer.
Remedy
a few seconds;
• turn the appliance back on and
repeat the washing program.
If the failure is reported again, call a
service technician.
• Turn off the appliance and wait for
a few seconds;
• turn the appliance back on and
repeat the washing program.
If the failure is reported again, call a
service technician.