Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Smeg LBS106F2
Summary of Contents for Smeg LBS106F2
-
Page 1: Washing Machine
LBS86F2 LBS106F2 Lavatrice Washing Machine 2820522799_IT/230512.1005... -
Page 2: Important Safety Instructions
1 Important safety instructions • Never touch the plug with wet hands! Never unplug by pulling on the cable, always pull out This section contains safety instructions that will by grabbing the plug. help protect from risk of personal injury or property • Use detergents, softeners and supplements damage. Failure to follow these instructions shall suitable for automatic washing machines only. void any warranty. • Follow the instructions on the textile tags and General safety on the detergent package. • 8 years and older children and people with • The product must be unplugged during reduced physical, sensory, and mental abilities installation, maintenance, cleaning and as well as unskilled or inexperienced persons repairing procedures. can use this appliance provided that they are •... -
Page 3: Appropriate Installation Location
Make sure that the water inlet and discharge If you want to use both water inlets of the hoses as well as the power cable are not product, connect the hot water hose after folded, pinched or crushed while pushing removing the stopper and gasket group from the product into its place after installation or the hot water valve. (Applies for the products cleaning procedures. supplied with a blind stopper group.) Appropriate installation location Models with a single water inlet should not be connected to the hot water tap. In such • Place the machine on a rigid floor. Do not a case the laundry will get damaged or the place it on a long pile rug or similar surfaces. product will switch to protection mode and will • Total weight of the washing machine and the not operate. dryer -with full load- when they are placed Do not use old or used water inlet hoses on on top of each other reaches to approx. 180 kilograms. Place the product on a solid the new product. It may cause stains on your laundry. and flat floor that has sufficient load carrying 1. Connect the special hoses supplied with the capacity! product to the water inlets on the product. -
Page 4: Adjusting The Feet
situations and to ensure smooth water intake and discharge of the machine, fix the end of the discharge hose tightly so that it cannot come out. • The hose should be attached to a height of at least 40 cm, and 100 cm at most. • In case the hose is elevated after laying it on the floor level or close to the ground (less than 40 cm above the ground), water discharge becomes more difficult and the laundry may come out excessively wet. Therefore, follow the heights described in the figure. 1. Loosen the lock nuts on the feet by hand. 2. Adjust the feet until the product stands level and balanced. 3. Tighten all lock nuts again by hand. • To prevent flowing of dirty water back into the machine and to allow for easy discharge, do not immerse the hose end into the dirty water or drive it in the drain more than 15 cm. If it is too long, cut it short. • The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched between the drain and the Do not use any tools to loosen the lock nuts. machine. -
Page 5: Things To Be Done For Energy Saving
3 Preparation To prepare the product for washing laundry, perform first operation in Drum Cleaning Things to be done for energy saving programme. If your machine is not featured with Following information will help you use the product Drum Cleaning programme, use Cottons-90 in an ecological and energy-efficient manner. programme and select Additional Water or Extra • Operate the product in the highest capacity Rinse auxiliary functions as well. Before starting allowed by the programme you have selected, the programme, put max. 100 g of powder but do not overload; see, "Programme and anti-limescale into the main wash detergent consumption table". compartment (compartment nr. II). If the anti- • Always follow the instructions on the limescale is in tablet form, put only one tablet into detergent packaging. compartment nr. II. Dry the inside of the bellow • Wash slightly soiled laundry at low with a clean piece of cloth after the programme temperatures. has come to an end. •... -
Page 6: Correct Load Capacity
This will reduce pilling. compartment (compartment nr. I). • Laundry that are subjected to materials such • Do not select a programme with prewash if as flour, lime dust, milk powder, etc. intensely you are using a detergent bag or dispensing must be shaken off before placing into the ball. Place the detergent bag or the machine. Such dusts and powders on the dispensing ball directly among the laundry in laundry may build up on the inner parts of the the machine. machine in time and can cause damage. • If you are using liquid detergent, do not forget Correct load capacity to place the liquid detergent cup into the main wash compartment (compartment nr. II). The maximum load capacity depends on the type Choosing the detergent type of laundry, the degree of soiling and the washing The type of detergent to be used depends on the programme desired. - Page 7 • Do not use bleaching agent and detergent by mixing them. • Use just a little amount (approx. 50 ml) of bleaching agent and rinse the clothes very well as it causes skin irritation. Do not pour the bleaching agent onto the clothes and do not use it for coloured clothes. • When using oxygen based bleaches, If the product does not contain a liquid follow the instructions on the package and detergent cup: select a programme that washes at a lower • Do not use liquid detergent for the prewash in temperature. a programme with prewash. • Oxygen based bleaches can be used together • Use the detergent manufacturer's measuring with detergents; however, if its thickness is cup and follow the instructions on the not the same with the detergent, put the package. detergent first into the compartment nr. “2” • Liquid detergent stains your clothes when in the detergent drawer and wait until the used with Delayed Start function. If you are detergent flows while the machine is taking in going to use the Delayed Start function, do water. Add the bleaching agent from the same...
-
Page 8: Tips For Efficient Washing
Tips for efficient washing Clothes Light colours and Delicates/ Colors Dark colors whites Woolens/Silks (Recommended (Recommended (Recommended (Recommended temperature range temperature range temperature range temperature range based based on soiling level: based on soiling based on soiling on soiling level: cold-40C) 40-90C) level: cold-40C) level: cold-30C) It may be necessary to pre-treat the Powder and stains of perform liquid detergents prewash. Powder recommended for Prefer liquid and liquid detergents Liquid detergents... -
Page 9: Operating The Product Control Panel
4 Operating the product Control panel 1 - Programme Selection knob (Uppermost 5 - Auxiliary Function buttons position On/Off) 6 - Delayed Start button (in some models) 2 - Programme Follow-up indicator 7 - Start / Pause button 3 - Temperature Adjustment button 4 - Spin Speed adjustment button Preparing the machine When selecting a programme, always Make sure that the hoses are connected tightly. consider the type of fabric, colour, degree of Plug in your machine. Turn the tap on completely. soiling and permissible water temperature. Place the laundry in the machine. Add detergent Always select the lowest required and fabric softener. temperature. Higher temperature means Programme selection higher power consumption. -
Page 10: Additional Programmes
• Lana (Woollens) If you wish to drain only the water without spinning Use this programme to wash your woolen clothes. your laundry, select the Pump+Spin programme Select the appropriate temperature complying and then select the No Spin function with the help with the tags of your clothes. Use appropriate of Spin Speed Adjustment button. Press Start / detergents for woolens. Pause button. Additional programmes Use a lower spin speed for delicate laundries. Temperature selection For special cases, additional programmes are available in the machine. Whenever a new programme is selected, the Additional programmes may differ according recommended temperature for the selected to the model of the machine. programme appears on the temperature indicator. • Cotone Eco (Cotton Economic) To decrease the temperature, press the You may wash your normally soiled durable cotton Temperature Adjustment button. Temperature will and linen laundry in this programme with the decrease gradually. highest energy and water saving compared to If the programme has not reached the heating all other wash programmes suitable for cottons. -
Page 11: Programme And Consumption Table
Programme and consumption table Auxiliary functions Programme Temperature Cotone 2.00 1600 • • • • • • Cold-90 Cotone 1.35 1600 • • • • • • Cold-90 Cotone 0.70 1600 • • • • • • Cold-90 Cotone Eco 60** 0.85 1600 •... -
Page 12: Auxiliary Function Selection
Auxiliary function selection in the final rinsing water in order to prevent them from getting wrinkled when there is no water in Use the following auxiliary functions according the machine. Press Start / Pause button after this to your daily needs. Select the desired auxiliary process if you want to drain the water without functions before starting the programme. spinning your laundry. Programme will resume and Furthermore, you may also select or cancel complete after draining the water. auxiliary functions that are suitable to the running If you want to spin the laundry held in water, adjust programme without pressing the Start / Pause the Spin Speed and press Start / Pause button. button when the machine is operating. For this, The programme resumes. Water is drained, the machine must be in a step before the auxiliary laundry is spun and the programme is completed. function you are going to select or cancel. • Soaking If the auxiliary function cannot be selected or The Soaking auxiliary function ensures better canceled, light of the relevant auxiliary function will removal of stains ingrained into the clothes by blink 3 times to warn the user. holding them in the detergent water prior to startup Some functions cannot be selected together. of the programme. For example, Prewash and Quick Wash. •... -
Page 13: Starting The Programme
Programme Selection knob to any programme. operating. Thus, Delayed Start function will be canceled. The Progress of programme End/Cancel light flashes continuously. Then, select Progress of a running programme can be followed the programme you want to run again. Press Start from the Programme Follow-up indicator. At / Pause button to start the programme. the beginning of every programme step, the Starting the programme relevant indicator light will turn on and light of the Press Start / Pause button to start the programme. completed step will turn off. Programme follow-up light showing the startup of You can change the auxiliary functions, speed the programme will turn on. and temperature settings without stopping the programme flow while the programme is running. If no programme is started or no key is To do this, the change you are going to make must pressed within 1 minute during programme be in a step after the running programme step. If selection process, the machine will switch the change is not compatible, relevant lights will to Pause mode and the illumination level of flash for 3 times. the temperature, speed and loading door indicator lights will decrease. Other indicator If the machine does not pass to the spinning lights and indicators will turn off. Once the step, Rinse Hold function might be active Programme Selection knob is rotated or or the automatic unbalanced load detection any button is pressed, indicator lights and system might be activated due to the indicators will turn on again. -
Page 14: Maintenance And Cleaning
Adding or taking out laundry be cleaned. Press the Start / Pause button to switch the Wash the detergent drawer and the siphon machine to pause mode. The programme with plenty of lukewarm water in a washbasin. follow-up light of the relevant step during Wear protective gloves or use an appropriate which the machine was switched into the brush to avoid touching of the residues in the pause mode will flash. drawer with your skin when cleaning. Insert the Wait until the Loading Door can be opened. drawer back into its place after cleaning and Open the Loading Door and add or take out make sure that it is seated well. the laundry. Close the Loading Door. Make If your detergent drawer is the one indicated in changes in auxiliary functions, temperature the following figure:... - Page 15 clogging the pump impeller during discharge of Discharging the water when the product does not washing water. Thus, the water will be discharged have an emergency draining hose: without any problem and the service life of the pump will extend. If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is clogged or in every 3 months. Water must be drained off first to clean the pump filter. In addition, prior to transporting the machine Place a large container in front of the filter to (eg., when moving to another house) and in case catch water from the filter. Loosen pump filter of freezing of the water, water may have to be (anticlockwise) until water starts to flow. Fill the drained completely. flowing water into the container you have placed Foreign substances left in the pump filter may in front of the filter. Always keep a piece of cloth damage your machine or may cause noise handy to absorb any spilled water. When the water problem. inside the machine is finished, take out the filter In order to clean the dirty filter and discharge the completely by turning it. Clean any residues inside water: the filter as well as fibers, if any, around the pump Unplug the machine to cut off the supply power. impeller region. Install the filter.
-
Page 16: Technical Specifications
6 Technical specifications LBS106F2 LBS86F2 Models (EN) Maximum dry laundry capacity (kg) Height (cm) Width (cm) Depth (cm) Net weight (±4 kg.) 230 V / 50Hz 230 V / 50Hz Electrical input (V/Hz) Total current (A) 2200 2200 Total power (W) 1000 Spin speed (rpm max.) 1.35 1.35 Stand-by mode power (W) Off-mode power (W) 0.25 0.25 Technical specifications may be changed without prior notice to improve the quality of the product. Figures in this manual are schematic and may not match the product exactly. Values stated on the product labels or in the documentation accompanying it are obtained in laboratory conditions in accordance with the relevant standards. Depending on operational and environmental conditions of the product, these values may vary. This appliance’s packaging material is recyclable. Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. Your appliance also contains a great amount of recyclable material. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. We thank you doing your part to protect the environment. -
Page 17: Troubleshooting
7 Troubleshooting Programme cannot be started or selected. • Washing machine has switched to self protection mode due to a supply problem (line voltage, water pressure, etc.). >>> To cancel the programme, turn the Programme Selection knob to select another programme. Previous programme will be cancelled. (See "Canceling the programme") Water in the machine. • Some water might have remained in the product due to the quality control processes in the production. >>> This is not a failure; water is not harmful to the machine. Machine vibrates or makes noise. • Machine might be standing unbalanced. >>> Adjust the feet to level the machine. • A hard substance might have entered into the pump filter. >>> Clean the pump filter. •... -
Page 18: Product Fiche
PRODUCT FICHE Complying Commission Delegated Regulation (EU) No 1061/201 Supplier name or trademark SMEG SMEG Model name LBS106F2 LBS86F2 Rated capacity (kg) Energy efficiency class Annual Energy Consumption (kWh) Energy consumption of the standard 60°C cotton programme at 0.847 0.847 full load (kWh) Energy consumption of the standard 60°C cotton programme at...