Table of Contents
Advertisement
3-10 PC Health Status
This section shows the Status of you CPU, Fan, and Warning for overall system status. This
is only available if there is Hardware Monitor onboard.
Show H/W Health in Post
Shutdown Temperature
Smart FAN Configuration
VLDT
VDIMM
NBVCC
Vcore
CPU Temperature
SYS Temperature
CPUFAN
SYS FAN1
SYS FAN2
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Show PC Health in Post
During Enabled, it displays information list below. The choice is either Enabled or Disabled
Shutdown Temperature
This item can let users setting the Shutdown temperature, when CPU temperature over this
setting the system will auto shutdown to protect CPU.
PS CPU Smart FAN Configurations
CPU Full-Speed Temp
This item allows you setting the FAN works in full speed when the temperature over the value
which out set. If the temperature below the value but over the Idle Temperature, the FAN
will works over 60% of full speed, and the higher temperature will gain higher FAN speed,
after over the temperature which this item setting, the FAN works in full speed.
CPU Idle Temp
This item allows you setting the FAN works in 60% of full speed, when the temperature
lower than the temperature which you setting.
CPU Temperature/ SYS Temperature /CPUFAN SYSFAN1, SYSFAN2 Speed/VLDT/
VDIMM/Vcore/NBVCC
This will show the CPU/FAN/System voltage chart and FAN Speed.
3-11 Thermal Throttling Options
CPU Thermal-Throttling
CPU Thermal-Throttling Temp
CPU Thermal-Throttling Duty
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Phoenix – AwardBIOS CMOS Setup Utility
PC Health Status
Enabled
Disabled
Press Enter
1.27V
1.95V
1.11V
1.35V
46 ° C
36 ° C
2525 RPM
0 RPM
0 RPM
F6:Optimized Defaults
Phoenix – AwardBIOS CMOS Setup Utility
Thermal Throttling Options
Disabled
F6:Optimized Defaults
F7:Standard Defaults
70
50%
F7:Standard Defaults
33
Item Help
Menu Level >
Item Help
Menu Level >
Advertisement
Table of Contents
